Review Questions
1. The Project was to make a robot that can cross three tables with two three inch gaps in between each table and get to the end of the third table within 6 inches of the end
2. We need to know how the LabView software works to program EV3 bricks and use a set distance.
3. We built multiple prototypes programming wise and bot wise once the final robot was built we made the last program and had the set location to go the certain distance and we achieved our goal
4. The final product was a working robot that met the goal we were given.
5. At times negative and at times positive feedback was received.
6. I learned how the LabView program works with the EV3.
7. If I were to do this over again I would not have attempted to rely on sensors as much.
1. The Project was to make a robot that can cross three tables with two three inch gaps in between each table and get to the end of the third table within 6 inches of the end
2. We need to know how the LabView software works to program EV3 bricks and use a set distance.
3. We built multiple prototypes programming wise and bot wise once the final robot was built we made the last program and had the set location to go the certain distance and we achieved our goal
4. The final product was a working robot that met the goal we were given.
5. At times negative and at times positive feedback was received.
6. I learned how the LabView program works with the EV3.
7. If I were to do this over again I would not have attempted to rely on sensors as much.